Foredom K.1050 Manual do Utilizador

Operation and Maintenance Manual for K.1050 Brushless Micromotor KitFOREDOM®For Your Safety:Read this Manual before operating your Foredom Micromotor

9Accessory more than 11⁄2″ 1″ 3/4″ 1/4″ 1/8″ 3/32″ less than 3/32″Diameter (40mm) (28– 40mm) (18 –28mm) (8– 18mm) (4 –8mm) (2 –4mm) (less than 2mm)Ro

Trouble Check Points Corrective ActionsMake sure that the Power Cord is correctly Correctly plug in the Power Cord.plugged into the outlet and the

For More InformationFor more information on Foredom machines, handpieces or accessories, contact your local dealer.When no local dealer is available,

Safety InstructionsA Micromotor Handpiece is a high speed rotary power tool which can be dangerous and cause serious injury if it is not used properly

2Components1 Control Unit (HP4-717)2 Speed Display 3 Motor On/Off Switch 4 Motor On Indicator Light 5 Auto Cruise Switch 6 Auto Cruise On Indicat

AC Power Input (Fig. 4)1. Check the label on the rear of the Control Unit tomake sure that the electrical specifications matchyour AC power.2. If the

Set-up and Electric Connection 1. Fix the Handpiece Holder 22 to the right side of theControl Unit with screw and washer. (Fig.7).2. Plug the Handpiec

Foot Mode Operation continued3. Press the Foot Pedal 24 to run the motor from start to a maximum speed (set by the speed control knob).4. To increase

CAUTION• Do not exceed the maximum operating speed of the bur or accessory in the handpiece to avoid personal injury.• Before turning off the Power Sw

Using the Motor Handpiece (MH-150)Changing AccessoriesBurs and other accessories can be inserted orremoved from the handpiece collet when the colletis

CAUTIONIt is recommended that a bur be kept in the chuck at all times. Do not operate the handpiece without a bur in the chuck.• Use only recommended